[分享] 真正从光盘上自动安装98和GHOST恢复的 img 镜像更新改进
@echo off
set RAMD=
set CDROM=
echo.
echo Preparing to start your computer.
echo This may take a few minutes. Please wait...
echo.
rem c:\findramd
findramd
if errorlevel 255 goto no_ramdrive
if not errorlevel 3 goto no_ramdrive
goto do_shift
:loop
if errorlevel %1 goto no_shift
:do_shift
set cdrom=%2
shift
shift
if not %1*==* goto loop
goto no_ramdrive
:no_shift
set ramd=%2
if "%RAMD%"=="C" goto c_drive
goto success
:c_drive
echo Windows 98 has detected that drive C does not contain a valid FAT or
echo FAT32 partition. There are several possible causes.
echo.
echo 1. The drive may need to be partitioned. To create a partition on the drive,
echo run FDISK from the MS-DOS command prompt.
echo.
echo 2. You may be using third-party disk-partitioning software. If you are using
echo this type of software, remove the Emergency Boot Disk and restart your
echo computer. Then, follow the on-screen instructions to start your computer from
echo a floppy disk.
echo .
echo 3. Some viruses also cause your drive C to not register. You can use a virus
echo scanning program to check your computer for viruses.
echo.
goto success
:no_ramdrive
echo The Windows 98 startup disk could not create a temporary drive for the
echo diagnostic tools. This may be because this computer has less than the
echo minimum required extended memory.
echo.
:success
以上是EASYBOOT自带setup98.img 里SETRAMD.BAT的内容,在加入你所写的那些的时候,它里面的这些内容是否要删掉?
